Rain-X Removal for Windshield Repair

   X-Phobic - hydrophobic coating remover (patent pending) is for the removal of Rain-X to allow windshield repair adhesives to bond to the windshield glass. Without removal of Rain-X the windshield repair resin will be blocked from the glass and the stone break or crack cannot be repaired. This will cause the consumer to have to pay hundreds of dollar for a new windshield and the windshield repair technician loses a repair job. Currently windshield repair technicians are losing hundreds of dollars per month due to the presence of Rain-X on the windshield.

This chemical mixture is a Rain-X remover for windshield repair and it will also remove carwash wax and detergents, moisture and other contaminants.

Directions: Some technicians are reporting that Rain-X is on 40% of windshields. You should test every windshield for Rain-X before starting the repair by placing a drop or two of water on the windshield surface. If it beads and rolls, there is a hydrophobic coating, most likely Rain-X. If the water rolls down and leaves a line of water then there is none.

Directions for a stone break: Use a windshield repair tool to inject and completely fill the break with the hydrophobic coating remover. Allow to evaporate which will usually take one to five minutes depending on ambient temperature and the temperature of the glass. The warmer the temperature the faster it will evaporate. If it is not evaporated in five minutes use a heat gun or blow dryer for five seconds. You can also use a heat gun or blow dryer anytime after it has been in the break for 90 seconds. Note: Immediately wipe off any excess from the windshield surface.

Directions for a crack: Inject by capillary action or injector slide. If the crack is vertical capillary action may work. Horizontal cracks must be injected by filling an injector and sliding it by hand along the entire crack. Note immediately wipe any excess off the windshield surface.

Directions for the Pit only: Place a drop above the pit and let it roll into the pit before doing the repair. Wipe any excess off the windshield surface. Allow to evaporate, then do the repair.

What to Charge the customer: Our MSRP for Rain-X removal is $10.00. This is to cover your product cost and labor.

Purchase Price: One bottle for $39.95 will decontaminate over 100 breaks. Don’t lose another job to Rain-X !

To Order X-Phobic click here