The First and Only Adhesion Promoter for Windshield Repair

 

 

Xtra Bond (patent pending) is an adhesion promoter for windshield repair which will allow windshield repair adhesives to have a greater mechanical and chemical bond to the windshield glass by etching and priming the surface of the crack(s).

 

Directions for a stone break: Use a windshield repair tool to inject and completely fill the break with Xtra Bond. Allow to evaporate which will usually take one to five minutes depending on humidity, ambient temperature and the temperature of the glass. The warmer the temperature the faster it will evaporate. If it is not evaporated in five minutes use a heat gun or blow dryer for five seconds. You can also use a heat gun or blow dryer anytime after it has been in the break for 90 seconds. Placing your tool in the vacuum mode will speed evaporation. Wipe off excess on windshield surface immediately.

 

Directions for a crack: Inject by capillary action for vertical cracks and by injector slide for horizontal cracks.  We also recommend you prime the edge area (the four inches from the edge) of an edge crack with primer resin after the Xtra Bond has evaporated. Wipe off excess on the windshield surface immediately.

 

Directions for the Pit only: Place a drop above the pit and allow it to roll into the pit before doing the repair. Allow to completely evaporate including any chemical that seeped into the break. Wipe off excess immediately.

 

Purchase Price: One bottle for $39.95 will treat over 100 breaks.  Click here to order.